Cut scores

[ATDoel]

If you failed, post your cut score and test below.  Remember, this test was all just data for you to pass the next one!

 

[aspiringWRE_PE]

WRE 44/80

 

[Saul Good]

Power 49/80

 

[Takk90]

Electrical: Power, 48/80.

 

[hardhatsandpinkshoes]

Civil: Structural - 49/80

 

[user 37873]

Civil: transportation: 41/80

 

[Gonzaga]

Civil: Structural - 48/80

 

[MspSdf]

Civil: transportation: 41/80

Oh no. What was the AM/PM split?

I feel like I will fail with a 45ish. We shall see tomorrow if I get the mail from MN board.

 

[kcg5]

Civil: Geotech: 48/80 (AM: 26, PM: 22)

 

[Acute Fungi]

Civil Construction - 26 am,  22 pm for 48/80.  Texas gave me a grade of 67.

 

[Shinken]

Civil Transportation 47/80 (28 am, 19 in pm)

 

[ihave2PE]

Civil Construction: 21/22 , guessing from my results graph I’m thinking the cut score was close to 57 

 

[SDB]

Civil: Geotechnical: 46/80.  (Am 29, pm 17)

 

[Blockchain_PE]

Civil Construction - 26 am,  22 pm for 48/80.  Texas gave me a grade of 67.

49/80...68%  (CONSTRUCTION: TEXAS). IT'S HORRIBLE. CAN'T UNDERSTAND HOW DAMN NCEES GIVES THE PASS AND FAIL SCORES. ITS SO CONFUSING. 

 

[Ajax33]

49/80...68%  (CONSTRUCTION: TEXAS). IT'S HORRIBLE. CAN'T UNDERSTAND HOW DAMN NCEES GIVES THE PASS AND FAIL SCORES. ITS SO CONFUSING. 

The passing score was probably somewhere in the 54-57 range. What was your AM-PM split?

 

[user 37873]

Oh no. What was the AM/PM split?

I feel like I will fail with a 45ish. We shall see tomorrow if I get the mail from MN board.

morning was 25/40 afternoon 16/40.  Not surprised at all, I could have prepared much better.  I studied plenty of hours but the focus during my studying was off - and I should have practiced more with keeping under 6 minutes per question!!

 

[Blockchain_PE]

The passing score was probably somewhere in the 54-57 range. What was your AM-PM split?

28 Morning and 21 Afternoon.  I can't believe my afternoon score was that low.  I almost wanted to appeal.  I walked out with pretty good confident that PM was going to make a difference and here i am again.   According to my score it is 62% and cut scores is 68%.  I think the range you said is probably correct.  Its not like I could have got 2 more question correct to make that 70%.  Not sure how NCEES get that 70% pass.  Wish there was diagnostic for the people who passed.  NCEES plays that politics not to disclose the information of passed students.  

 

[GeoDude_PE]

28 Morning and 21 Afternoon.  I can't believe my afternoon score was that low.  I almost wanted to appeal.  I walked out with pretty good confident that PM was going to make a difference and here i am again.   According to my score it is 62% and cut scores is 68%.  I think the range you said is probably correct.  Its not like I could have got 2 more question correct to make that 70%.  Not sure how NCEES get that 70% pass.  Wish there was diagnostic for the people who passed.  NCEES plays that politics not to disclose the information of passed students.  

I doubt the cut score was 54-57. I haven't seen one fail score yet that was at the 52/53 range. If you were 68% curved score for Texas then you were very close (either 1 or 2 problems) from the 70% Texas curved score which = PASS on NCEES

 

[Str. Entrepreneur]

We received a fail score of 51 in structural in another thread. Which means the str cut score was probably 52. That’s on the lower side of the 52-56 we were told to expect. This exam was difficult by most admissions. 

 

[phirra]

Civil Structural - AM-28, PM-20, Total 48

This was second attempt with an exact same score last time