Treat bag!

Professional Engineer & PE Exam Forum

Help Support Professional Engineer & PE Exam Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

EL Nica PE

Joda
Joined
Apr 25, 2006
Messages
189
Reaction score
0
See attachments

Question No I

A new industrial development for a port extension consists of several large container warehouses

for storage of cargo. The site is located at Labenne in France. The stanchions of the new

warehouses are to be supported on shallow foundations of which typical dimensions are shown

in Figure 1.1. The site is underlain by sands and the variation of the standard penetration

resistance, cone penetration resistance and pressuremeter limit pressures are depicted in Figure

1.2. The soil friction angles derived from shear box tests are summarized in Figure 1.3. Figure

1.4 shows index properties reported from the site investigation. NOTE: Although the data in

Fig. 1.4 are quite reliable above the groundwater table, the data are affected by significant

sampling disturbance effects below the groundwater table (due to cave-in of the borehole).

Based on the data available to you, carry out the following tasks:

a. Estimate the ultimate bearing capacity of the foundation using the methods given in the 1.364

Course Notes.

b. Calculate the factor of safety for a vertical working load of 2000 kN acting at each stanchion.

c. How would your answer change if there is an additional moment of 500 kNm due to lateral

loads on the stanchions?

d. Use the method of Burland and Burbridge (1984) to calculate the immediate settlement of the

foundation. Consider only the vertical load of 2000 kN. What would be the settlement after a

period of operational life of 90 years?

e. For the same loading condition and operational life as in (e), re-calculate the immediate and

long term settlements using the method of Schmertmann (1970).

Question No. 2

At the Post Office Square site in Homework No. 1, the Owner suggested that an alternative

scheme involving a single basement be explored. The new scheme is shown in Figure 2.1. A

raft would be constructed at an elevation of 0.0 feet (based on Boston City datum) to carry the

foundation loads of the entire building. The soil profile and the soil parameters are summarized

in Figures 2.2 and 2.3. The coefficient of consolidation cv = 0.2 ft2/day and the coefficient of

secondary compression ca = 0.001 for the clay layers. Based on the information given, carry out

the following tasks:

a. Interpret the undrained shear strength of the clay using the SHANSEP approach of Ladd and

Foot (1974) assuming S = 0.2 and m = 0.8.

b. Calculate the ultimate bearing capacity of the raft.

c. If a factor of safety of 2.0 is required by the local Building Authority, how many floors can

the building be designed to, if the working live load is 0. 1 tsf per floor and 0.2 tsf for the

basement. Assume the structural dead load to be 0.5 tsf per floor and 0.36 tsf for the

basement.

After much discussion, a 13 storey high structure with a single basement was chosen. For this

case:

d. Calculate the immediate settlement using the method of D'Appoloniaet al (1971). Assume K0

= K0NC (OCR)n, where K0NC = 0.5 and n = 0.4.

e. Estimate the consolidation settlement assuming that the loads are applied instantaneously.

f. Estimate the long term creep settlement for a design life of 90 years.

g. If the actual construction period is 12 months, what amount of settlement can be expected

after the end of construction for the same design life?

 
Back
Top