I'm planning to taking the PE exam and was wondering where exactly is the Chicago test location? Does anyone have the address? I did some searches but could not find it. It's appreciated and will be of great help in deciding which location to take it in. Thanks!
Chicago Location
- Thread starter Knightro
- Start date
Help Support Professional Engineer & PE Exam Forum:
RIP - VTEnviro
His Memory Eternal
If you can't figure it out, you probably shouldn't be taking the test to start with.
matt267 PE
"1000000 warning points" Club Member
- Joined
- Dec 2, 2013
- Messages
- 46,596
- Reaction score
- 3,629
You're better off calling your engineering board:
http://ncees.org/exams/state-pages/illinois-exam-registration/illinois-pe/
Good luck on the exam.
Judowolf PE
Well-known member
^^This is probably true VT
Last edited by a moderator:
Capt Worley PE
Run silent, run deep
Mark Leyner
Well-known member
- Joined
- May 27, 2013
- Messages
- 59
- Reaction score
- 4
When I took exams there last spring, they were held at the Midwest Conference Center 401 W Lake Street Northlake, IL 60164. It's a decent facility, but there isn't enough parking and it's a little tricky to get in and out of the facility. I sent an e-mail to CTS asking about the location prior to the exam because I was travelling from out-of-state and needed to make my hotel reservation. I would suggest you confirm with CTS prior to planning on the address I gave you without verifying it for yourself. For those who haven't been through Illinois' process, the test location is not published information, and it's apparently not always held at the same location, so it's understandable (and perfectly reasonable) that this question is being asked.
Good luck
Good luck
The test location is not given, just a city- Northlake which is a small Chicago suburb, so this is a valid question.
Similar threads
