GustavoSilvano
Member
- Joined
- Oct 3, 2016
- Messages
- 6
- Reaction score
- 1
Hello there!I'm in a project that we're designing a rolling table to transport a bundle of steel rod. To improve the productivity, I want to increase the speed of the gearmotor with an inverter.The plate info of the gearmotor shows that the nominal rotation is 1780 rpm. But in contact with the manufacturer, it shows that it can run safety with 2800 rpm.My question is. What a high frequency feeding source can cause to my motor? It will reduce it lifespan?
Some more info.
The duty cicle is about 10 seconds in every 5 minutes. So it only run for 10 seconds, then it stays down for 5 minutes, then run again for 10 seconds.
The gearmotor is of 1,5 HP, and if fed with 440 V.
The normal currently of work, with load, is about 1,6 A.
Thanks
Some more info.
The duty cicle is about 10 seconds in every 5 minutes. So it only run for 10 seconds, then it stays down for 5 minutes, then run again for 10 seconds.
The gearmotor is of 1,5 HP, and if fed with 440 V.
The normal currently of work, with load, is about 1,6 A.
Thanks