According to the NEC 430.6 (A) (1), when will I use Nameplate Full Load Current value instead of Table 430.250 value? If I do not meet the speed or torque requirements in NEC 430.6 (A)(1) and my name plate current is less than table value, I use Table Value. If name plate current is greater than table value, I use nameplate value. I see in the NEC 430.6 (A)(1) where to use table value, but do not see it written where to use name plate value when the name plate full load current is greater than table value. I see it for overload protection.
Last edited by a moderator: