Application of wind loads

Professional Engineer & PE Exam Forum

Help Support Professional Engineer & PE Exam Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Br_Engr

Well-known member
Joined
Sep 28, 2020
Messages
131
Reaction score
86
Ok. Flaunting my ignorance for all to see here.

Reviewing wind loads, and it DOES look something like this (Thank you @NikR_PE):

1024.jpg

and have a question about the application of the design wind pressures.

Examples show that the design wind pressure on the windward wall is a uniform pressure for the first 15' (q15) and then varies linearly up to the wind pressure at the mean roof height (qh).

My question is: Where is it stipulated that a uniform pressure is applied for the first 15'? Is a code requirement or just convention? The design pressure figure from ASCE-7 shows the parabolic pressure distribution starting at 0 at ground level to qh, but also has a line representing (what I think to be) the uniform pressure component.

1629459881610.png

I was not able to find anything that explains the origins of this approach. I am not questioning this, just trying to understand where it comes from.

As always, thank you in advance for all of your help.

Br_Engr
 
If you're asking how the bottom 15' is implemented in the wind provisions, its by the Kz factor that is the same from 0-15'

If you're asking why they do that...don't think I can point to anything in the code about it. Plain old simplicity and conservatism probably.
 
Thank you. I understand how it is computed, just was not aware of the "why"
 

Latest posts

Back
Top