Search results

Professional Engineer & PE Exam Forum

Help Support Professional Engineer & PE Exam Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    Cycle Length

    HCM is one of the NCEES exam standards. Read HCM to get it and I can't help you, if you still do not understand. Good Luck!
  2. P

    Cycle Length

    I expected you to read it. I copied only few lines below from above link, which talks about HCM 2000. Isn't it NCEES exam design standards? Cycle Length and Split Settings HCM 2000 (10) provides a detailed description of computational procedures for cycle and split settings. The following...
  3. P

    Cycle Length

    Read this link. http://ops.fhwa.dot.gov/publications/fhwahop06006/chapter_3p1.htm
  4. P

    Cycle Length

    The following calculations and terms are important in determining signal timing plans: Critical Volume Lost Time (tL) Peak Hour Factor (PHF) Green Time Headway and Saturation Flow Rate (s) v/c Ratio Cycle Length © Capacity Critical Volume(Vc) During any given signal phase...
  5. P

    Cycle Length

    See attachment. Traffic Signal Design.pdf
  6. P

    Environment Problem - Morning Exam

    A wastewater treatment plant has an average flow of 12 M-gal/day and a peak to average flow ratio of 2.5. Determine the total volume of an aerated grit chamber if detention time is 3 min. a. 8316 cu.ft. b. 4500 cu.ft. c. 6127 cu.ft. d. 5512 cu.ft.
  7. P

    Burrow Pit problems

    Consider an embankment that has a volume of 200,000 cubic yards is to be compacted to a dry unit weight of 108 pcf at a moisture content of 19%. The soil is to be taken from a borrow pit wherein the soil has an insitu unit weight (total unit weight) of 122 pcf and a moisture...
  8. P

    Environment Problem - Morning Exam

    See attachment. Formulas.pdf
  9. P

    Environment Problem - Morning Exam

    CONCENTRATIONS AND SOLUTIONS 1 mg/l = 1 ppm 1 mg/l = 8.34 Lbs/ Million Gal Lbs, Chemical = Desired ppm X Flow, MGD X 8.34/Purity of Chemical 1 Mole = 1 Gram Molecular Weight per Liter of Solution 1 Normal = 1 Gram Equivalent Weight per Liter of Solution ppm...
  10. P

    Environment Problem - Morning Exam

    1. Calculate the BOD loading (lbs/day) on a pond if the influent flow is 390,000 gpd with a BOD of 245 mg/L.
  11. P

    All-in-One Civil PE Exam Guide by Indranil Goswami

    Don't get confused with this book. All you need for morning section is CERM.
  12. P

    NCEES degree Evaluation

    "While a master's degree does provide valuable education" Can you elaborate more about this? What is "valuable education"?
  13. P

    NEW YORK - RESULTS

    PE Hope, Where do you see the posting of license numbers? Can you post the link of website?
  14. P

    Where to download free NAVFAC DM 7.01 and 7.02?

    Non Geo-tech guys don't need NAVFAC at all.
  15. P

    Geotech Practice Problems

    Don't get confused with All in one book. I had bad experience. CERM is the best for morning session.
  16. P

    Geotech Practice Problems

    Hardly 4 days left. How is everybody doing?
  17. P

    Do I change to construction

    What did you register for? That's what you will be taking. Obviously you should prepare for it.
  18. P

    Triaxial Shear Test

  19. P

    All in one PE guide book

    All you need for morning portion is CERM. I had taken CERM , 6 minute solutions & All in one references in exam. I don't think that I had to look any other references besides CERM for morning portion. All in one reference alone will not help you at all. I personally thought that it was not...
  20. P

    Water Morning Civil

    Problems are not difficult. See some sample problems below 1. Two lagoons 700 ft by 500 ft, operated in parallel, are receiving an organic load of 203.8 mg/l of BOD5 from a community of 1700 people. What is the organic load, in lbs of BOD5 per acre per day? Organic load/lbs/BOD5/Day/ Acre...
Back
Top