Recent content by salmanshu322

https://www.pcbway.com/project/shareproject/Motion_Sensor_1.html this project have completely describe the instrumentation of sensor and its connection, check this out it will be really help full. connect detail of arduino and ESP32 connections.

flaming right hand rule show the direction of currrent in the megnatic field

It means actual winding power handling capacity is only 1015 KVA but this autotransformer can handle 5000 KVA means auto transformer can handle 5 times more power and 5 times smaller than a conventional 2 winding transformer

An electromagnet can be used for moving scrap steel from one place to another. In a scrapyard, a crane has a large iron disc that is not a permanent magnet. The crane operator lowers the electromagnet into a pile of scrap steel and then switches on the electricity.

go search on google scholar it contain nuemours reseacrh paper. it can help you

FE at 23 and PE at 26

https://www.pcbway.com/project/shareproject/Potentiometer__Switch___RCA_Socket_PCB_Boards_for_DIY_Audio_Amplifier.html this will help you in doing replacement of the joystick using reed switch. this project discussion will help you understand counter going to the digital pot.

thank you for this video really helpfull.

3@ - 480: @ is equal to theta Vd-Value * sqrt(3) 480 1@ - 277/480 Vd-Value 277

ye the answer should be :Vi = Vt + Id*Xd = 1+ 0.97*1.1j = 1.46 pu So, the voltage is 1.46 * 250 kV = 365.6 kV there can be mistake in solution manual.

we can use MVA Method, 40MVA in series with 25 MVA (1MVA/.04) and 40 X 25 / (40+25) = 15.38 MVA we find out that Fault is on the 480v bus 15.38MVA/(sqrt(3) * 480e-6MV) = 18,500A

clearly mention that 277V is single phase connected across L-N.

To create a wirewound resistor, one piece of wire would have to serve as the path for the electrical current to flow from one end of the resistor to the other. To create a resistor with a small resistance (or Ohm) value, use a thicker, shorter wire as the path between the two electrical leads.