Recent content by Golden Eagle PE

Ditto on the MERM.

In TX you have to get fingerprinted. I got that done and out of the way. There is another fee associated with that as well. Not sure about other states.

Same here. Two to a table. I felt that I had just enough space though and I put the rest of my books on floor next to me. I couldn't keep my watch on the table so I had to lay it on the floor in a way that I could look down and see it from time to time. I know I could have worn it on my wrist...

Me too.

3. Pay attention to the units.

Hopefully it does not take 10 weeks for everyone. This past exam in April, it only took TX 5 1/2 weeks to get the results out. Depends on the state.

When I took the afternoon portion of the exam, I went in knowing that it would suck, and it did. It is definitely a step up in difficulty (at least for me it was). Just work the problems as best as you can. If you see one that will take a long time or you have no idea how to do it, skip it. When...

I worked them multiple times. They are difficult, no doubt about it. Seek to understand the way they attack the problem in the solutions. Once I reviewed the solutions and re-worked problems, I started marking in the MERM next to equations that they used. If you feel you are weak on a certain...

Mechanical - 1st try

They are cheap too. I got mine for almost nothing on Amazon. Good luck with studying TFS.

Get Keenan and keys

BSME 2008 EIT 2008 PE 2014

Anyone know how long it takes the TX Board to release the passing percentages for the PE exam? I am curious.

Wow, that is high.

Working problems on my own is where I learned the most. It was not fun, but it worked.