Sign in to follow this  
Followers 0
Dan06

Assistance w/ Das: Bearing Capacity Problem 15.1

9 posts in this topic

Principles of Geotechnical Engineering (5th) Ed - Problem 15.1

Determine gross allowable bearing capacity. Use Terzaghi's bearing capacity factors.

Part A Given: soil unit weight = 120 lb/ft^3, c'=0, angle degrees = 40, Df = 3ft, B = 3.5ft

My approach:

Eq. 15.12: qu = (1.3 * c * Nc) + (q * Nq) + (1.4 * unit weight * B * Nunitweight)

Table 15.1 (Terzaghi's Bearing Capacity Factors) for given degrees:

Nc=95.66, Nq=81.27, Nunitweight=115.31

qall = qu / Fs, where Fs=4

qu = 48,629 lb/ft^2

qall = 12, 157 lb/ft^2

For part 15.1a I get 12,157 lb/ft^2; however the solutions indicate 13,368 lb/ft^2. I'm off on all subparts of this problem. Any thoughts? Are these type of problems representative of AM Breadth Geotech Problems?

Thanks in advance.

Share this post


Link to post
Share on other sites

Try using eq. 15.11 since this is a conrinuos footing; 15.12 is for square footing and has shape factors incorporated into it.

So q-ult= cNc+YDfNq +0.5YBNy = 0 + 29257.2 + 24215.1 = 53472.3 psf.

Good luck.

Share this post


Link to post
Share on other sites

Success - Thanks Badger!

Share this post


Link to post
Share on other sites

So, Badger is this mean that the solution in Das Book is wrong....13,368?

Share this post


Link to post
Share on other sites

no, I think it just means that you need to be careful before using B.C. equation.. this is where you can be tricked!!

Share this post


Link to post
Share on other sites

geo.....what you mean?.....where's the trick?

Share this post


Link to post
Share on other sites

geo.....what you mean?.....where's the trick?

The trick is in the type of foundation, if you use the shape factors you get 12,157psf vs if you donot use the shape factors you get 13,368psf. So be careful and read the question again and watch for key words.... I hope it helps.

Share this post


Link to post
Share on other sites

So, Badger is this mean that the solution in Das Book is wrong....13,368?

No, but you made me look. I hadn't finished the problem in the reply, only q-ultimate, q-all = 53472/4=13368.

I think in the test they will give you the shape factors or tell you whose to use. If you are in doubt I'd use the factors in the CERM. This book Principles of Geotechnical Engineering (5th) Ed doesn't go into shape factors much. I like the Principles of Foundation Engineering (5th) Ed by Das, it was real helpful to me on the exam. I recommend you getting it. I got used copy off B&N for $50, I still use it every so often.

Share this post


Link to post
Share on other sites

Thanks Badger!

I got it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0