Sign in to follow this  
Followers 0
Callan74

Vertical Curve Question

4 posts in this topic

Hey I have a quick question about vertical clearance on a vertical curve. When looking for vertical clearance on a curve do the equations change based on the location of the structure when compared to the PVI? Do I use one set of equations if the structure is before the PVI and another set if the structure after the PVI?

The basis of the question is from NCEES 2000 example 511 (question pg 105 and solution on pg 192) and the Goswami all in one example on page 694.

I am trying to get a better handle on vertical curves, I feel pretty good with horizontal curves and working on my weak points.

thanks,

C

Share this post


Link to post
Share on other sites

You can use equation 404.24 and fig 404.9 for both cases.

just remember to use the correct sign for h and v

if point on curve is to the left of PVI, h is negative

if point on curve is to the right of PVI, h is positive

if point on curve is below the PVI, v is negative

if point on curve is above the PVI, v is positive

Share this post


Link to post
Share on other sites

to figure the elevation of obstruct object or clearance, no need to use different formulas. It all the same. Just make sure, than when you calculate K=G_2-G_1/L, it could have negative value. But the rest of the calculations should be the same

Share this post


Link to post
Share on other sites

Thanks for the replies. Off to go study some more.

C

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0