Jump to content
Engineer Boards
Ramnares P.E.

Load due to deflection

Recommended Posts

Ramnares P.E.    1,406

Simple problem that I can't seem to rationalize.  For a given uniform beam supported on both ends I can calculate the load by rearranging delta = PL/AE.

For the calculated load, is P the load at each end or should I divide by two?

@Krakosky @thekzieg

Share this post


Link to post
Share on other sites
thekzieg    1,404

Let me see if I understand your question: You have a simply supported beam with a single point load. You know the midpoint deflection and you're trying to figure out what the point load is? 

Share this post


Link to post
Share on other sites
Ramnares P.E.    1,406

It actually is a uniform cross section bar that's supported by two bearings.  I know the deflection, area, material properties, and the distance between bearing centers, L.

As the bar deflects down, it imposes an axial load on the bearings, P.  So I rearranged and solved for P.  

 

Does each bearing see an actual load P or P/2?

Share this post


Link to post
Share on other sites
thekzieg    1,404

I think I understand. Each reaction would be P/2 (assuming both bearings get the same force applied) and the total force exerted by the bar would be P. If it helps keep things arranged in your head, think of the forces to the bearing as the reaction R, where P=2R, or R=1/2P.

The sum of the forces in any direction always equal 0 in structures world.

Share this post


Link to post
Share on other sites
Ramnares P.E.    1,406

That's exactly what I was thinking.  The total force imposed would be divided between the two bearings.  Thanks for the sanity check!

Share this post


Link to post
Share on other sites
thekzieg    1,404

Any time!

  • Like 1

Share this post


Link to post
Share on other sites
thekzieg    1,404

Trial by basic statics, I like it.

Share this post


Link to post
Share on other sites

Depending on the size of the beam, don't forget to include the distributed load due to beam weight.

Share this post


Link to post
Share on other sites
MA_PE    1,873

 

5 hours ago, Audi driver, P.E. said:

Depending on the size of the beam, don't forget to include the distributed load due to beam weight.

Absolutely.  Also. are the bearings on the end restrained from rotation?  If so the midpsan deflection would realistically fall somewhere between  a simple support and a fixed support.  The deflection for a fixed end condition is 1/4 of the deflection of a simple beam for the same concentrated load at the midspan.

 

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×