Sign in to follow this  
Followers 0
elminses

DOE, BOOST, BUCK, CONVENTIONAL AUTOTRASNFORMERS

10 posts in this topic

Spin - UP PE sample exams have a few questions on autotransformer types. Doe, Boost, Buck, Step-up, conventional.

I'm an electrical consulting engineer, i don't get much into circuit diagrams of internal workings of equipment. If someone could either supply or point me to a reference that has each type of autotransformer diagram drawn out so I can learn and be able to tell the difference between them it would be most appreciated.

Thanks ahead of time!

Share this post


Link to post
Share on other sites

i'd like to know too, please :)

Share this post


Link to post
Share on other sites

There's no such thing as a Doe autotransformer...I believe it is almost meant to be a joke, since there is such a thing as "buck" autotransformer.

Share this post


Link to post
Share on other sites

There is also a boost and stepup.

Share this post


Link to post
Share on other sites

For autotransformers, you should know step-up, step-down and the buck & boost.

Share this post


Link to post
Share on other sites

Here will be my assumptions based on your comments. Please correct if they are wrong.

step - up : will be where an auto transformer diagram has a small transformer stepping a larger transformer up to larger voltage. ex. 1200V + 120V = 1320V because the load requires 1320v

step - down : will be where an auto transformer diagram has a small transformer stepping a larger transformer down. ex. 1200V - 120V = 1080V because the load requires 1080V

buck boost : will be when an auto transformer diagram is + / - a voltage on a transformer. 1200V +/- 120v = 1080V-1320V because the load can take a span based on AC voltage.

I'm just wonder how these would look diagram wise, if someone could just doodle in paint so I can just see the diagram it would be most appreciated.

thanks again.

Share this post


Link to post
Share on other sites

I ran into this question last night and I found this website that really helped.


/>http://www.allaboutcircuits.com/vol_2/chpt_9/5.html

Basically the step up / step down depends on if the load or source is connected to the center tap between the two coils. The buck / boost is dependent on the polarity of the coils and how they are connected.

See the attached table for more details note the dot polarity of the coils for the buck and boost.

Hope this helps.

Share this post


Link to post
Share on other sites

Well for some reason the table did not upload correctly so I have attached it here as a jpg.

post-22678-0-17759700-1333854795_thumb.j

Share this post


Link to post
Share on other sites

Thanks again everyone for your help!

Share this post


Link to post
Share on other sites

thanks vskneifl for the upload!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0